R2D2 in glittering gold

IMG_0533

No it’s not subtle, but it is awesome! And better yet I got to embarrass my children in public at the midnight Rogue One premiere late last year. This skirt required 3.2 m of specialty print from Spotlight and no pattern. Pre-washing fabric is pretty much a belief system for me, but this time I didn’t because I wanted the crispness and body of the fabric just as it comes off the roll. The gaudy gold surface print also helps its stiffness but I think it will be droopier once it’s washed. I may or may not wear it again so I didn’t want to go to too much trouble with zips or buttons and decided on a simple half elasticated waist, of the sort you often find in children’s clothes (elastic at the back, flat waistband at the front). Because it was a last minute decision to make it at all, I sewed it the evening of the event I was wearing it to, so time was of the essence. I had cut it out the previous evening but started the actual sewing about 6pm.

IMG_0531

IMG_0534
Trying not to laugh at the cat antics
IMG_0528
Wrestling with Miles tabby cat

I had cut four panels, the full width of the fabric x 75cm long, and a waistband long enough to fit over my hips (I cut the waistband the width of some nice wide elastic I had in the drawer). The plan was to have the front of the waistband sit flat, with elastic inserted into the back, so I needed the front section to fit my waist measurement and the rest of the waistbands’s length to be in the back – after I joined the waistband into a loop, I marked the front centre, and the two side points accordingly.

I might decide to sell the skirt on Ebay later so I did make sure it was finished nicely, and sewed the four skirt panels together with French seams. I then marked the skirt into four equal sections with the marks halfway between each of the seams, so that the seams would be offset from the centre lines. I gathered the skirt to the waistband, wrong side of skirt to right side of the inside of the waistband, matching the marks. Since the back part of the waistband would get pulled in further by elastic, the back gathering didn’t have to get pulled in as tight as the front gathering.

It was all going so smoothly up to this point that I thought it was going to be over and done with in two hours flat, but of course I managed to put the waistband upside down with poor R2D2 standing on his head! There was about an hour of sulking, trying to convince myself I didn’t care, and popping out for take-away chicken and chips, but I knew it would bug me if I didn’t fix it, so after some sustaining tastiest-chicken-and-chips-in-the-world from our local shop, I unpicked and regathered the right way up. The one thing I should have done and didn’t think of, was to interface the front part of the waistband. It sits ok but would have been better interfaced.

Once the skirt was gathered onto the waistband, I ironed under the seam allowance on the other edge, and turned the waistband to the outside. I pinned it in place, then stitched just the back section  from one side point to the other, stitching over the previous seamline very close to the folded edge. I threaded a piece of elastic through the back waistband and tried the skirt on, adjusting it to a comfy fit, then sewed vertically across the waistband at the side points to anchor the elastic. Finally I stitched the front section of the waistband in place, and did a twice folded small hem on the bottom of the skirt, meaning all seams are enclosed.

IMG_0527

It was so much fun wearing this to the midnight screening. As I mentioned in my previous post I wore it with a black t-shirt, and a C-3PO brooch made from a lego mini-fig. There were heaps of people dressed in Star Wars cosplays – lots of Jedis and Vaders, some storm-troopers, a few Leias, plus many Star Wars t-shirts, quite a few amazing props like pilots’ helmets and cardboard ships, and a surprising number of space buns on both men and women. I wasn’t expecting to love this skirt so much, but I’m really pleased with it. So much so I think I might make another version in a more mainstream fabric. I did think I’d sell it after the one wear, but I’m finding the thought of parting with it is harder than I expected so maybe I’ll hang onto it and wear it to the next Star Wars premiere.

Knitting goodness

What is the one thing guaranteed to inspire a bit of knitting?
Procrastinating about an assignment for which the due date is imminent!
The weekend my uni work was due I got these pants knitted (and the assignment done). I’m consequently now on a knitting kick and have whipped up this little pinny, AND two more lots of lovely wool are currently winging their way to my needles.
The model was being particularly disobliging but still looks rather cute. The stripey pants look a bit short but they’re good with boots on, and I have a left-over ball of wool I can extend them with when she grows.
The pinny was fun, and knit up very fast in lovely thick yarn. The maths involved just about did my head in, but at least it did result in even holes in the end.